Morita Lubrina 2, Инструкция по эксплуатации, Страница: 11 / 48

9
5.2 Operation Panel: Name and Function of Switches and Indicator Lamps
Instructions for Use 2019-01-16
5.2 Operation Panel: Name and Function of Switches and Indicator Lamps
█ Switches
Line Selection Switches Start/Stop Switch
Mode 1 Selection Switch Mode 2 Selection Switch
5.2.1 Recommended Mode
Depending on the type of handpiece, you can choose from two modes. Each mode has different settings for oil
usage and blowing out (idle running) time.
The initial settings are Mode 1 for Lines 1 & 2, and Mode 2 for Lines 3 & 4. Use the chart below as a reference
for changing the settings as necessary.
p. 26 “7.3.4 Switching Maintenance Mode”
Always use Mode 2 for maintenance of speed increasing model contra angle handpieces. Using Mode 1 may result in a lack of lubricant.
* You can select and perform maintenance with Mode 2 for the handpieces recommended for Mode 1, but it may remain excess oil inside the hand-
piece when the maintenance is completed.
Start/Stop Switch
Mode 1 Selection Switch
Press this switch to start or stop lubrica-
tion.
Press this switch to select Mode 1 when
connecting handpieces recommended for
Mode 1.
Line Selection Switches
Mode 2 Selection Switch
Select desired line(s) from Line 1 through
4, for handpiece maintenance.
Press this switch to select Mode 2 when
connecting handpieces recommended for
Mode 2.
Handpiece Type
Recommended Mode
Mode 1
(Operating Time:
20 sec/handpiece)
Mode 2
(Operating Time:
40 sec/handpiece)
Air Turbine Handpiece
Straight Handpiece
Contra Angle Handpiece: Speed Reduction Model
Contra Angle Handpiece: Constant Speed Model
Contra Angle Handpiece: Speed Increasing Model
Air Scaler
Air Solfy (J. MORITA product)
Air Motor Air Torx (J. MORITA product)
Endodontic Motor
Tri Auto ZX (J. MORITA product)
Tri Auto ZX2 (J. MORITA product)
Dentaport ZX (J. MORITA product)
Root ZX II (J. MORITA product)
Tri Auto mini (J. MORITA product)