Morita AdvErL EVO, Инструкция по эксплуатации, Страница: 26 / 76

Instructions for Use 2018-08-23 24
2) Laser Emission Procedure
(1) Press the Ready Key.
•
The Ready lamp will light up to show that the unit will not
emit a laser beam.
•
The aiming beam will be emitted when you press the
Ready Key.
(2) Before using the laser, make sure the aiming beam is clear
and bright. (See page 21.)
(3) Depress the foot switch to its first level to check that spray
is properly emitted from the tip.
(4) Depress the foot switch all the way down to emit the laser
beam. The Ready lamp will change to Emission, and
beeps will sound continuously.
This photo shows the panel when the foot switch is depressed
all the way down and a laser beam is being emitted. If you
depress the foot switch only part of the way down, the spray
and the air will be emitted but the laser beam will not.
Depress the foot switch all the way down to emit the laser
beam.