E-10 SETTING OF COORDINATE SYSTEM
10)
Bring the tool close to the workpiece manually while
observing the clearance between the workpiece and
the tool through the window in the front door.
When the DOOR INTERLOCK key-switch is
placed in the
RELEASE
position, axis movement
is possible even if the front door is open. In this
case, rapid traverse is restricted to 5 m/min.
11)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
12)
Check for possible interference when the spindle is
rotated.
<Example>
Interference between the adjacent tools and
chuck (workpiece)
Interference between the fixture and chuck
(workpiece)
13)
After making sure that the spindle can be rotated
without interference, close the front door.
14)
Start the spindle manually, and adjust the spindle
speed as appropriate.
15)
Cut the workpiece in the handle feed operation to
eliminate run-out on the end face, O.D. and I.D. of
the workpiece.
16)
Retract the turret to the position where the cutting
tool will not interfere with the workpiece when the
turret head is rotated.
NOTE
DOOR UNLOCK
NOTE
