MANUAL OPERATION B-71
16
MANUAL OPERATION OF THE SERVO-CONTROLLED STEADY
REST (SERVO-CONTROLLED STEADY REST SPECIFICATION)
16-1
Moving the Servo-Controlled Steady Rest in Manual Operation
The servo-controlled steady rest can be moved in manual operation when the following modes are
selected.
•
Rapid traverse mode
•
Jog mode
•
Zero return mode
The following condition must be satisfied to move the steady rest in manual operation.
•
The steady rest has been retracted.
For automatic operation, refer to the PROGRAMMING MANUAL published separately.
<In the rapid traverse mode>
In manual operation, the servo-controlled steady rest is moved at the set rapid traverse rate.
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in either of the positions indicated below.
(ON)
(PANEL/EDIT)
4)
Select the rapid traverse mode (
) with the mode selection switch.
5)
Set the rapid traverse rate using the rapid traverse rate override switches.
In manual operation, even if the rapid override is set to 100%, the actual override value is
fixed at 50%.
6)
Press and hold down the steady rest switch for the direction in which motion is required.
The steady rest is moved at the rapid traverse rate while the switch is held down.
To stop axis feed, release the switch.
NOTE
NOTE
