B-66 MANUAL OPERATION
4.
For the machine equipped with a work rest (without workpiece unloading function),
the M631 (spindle-side work rest extend) command cannot be specified when the
tailstock is located in the negative region with respect to the parameter setting value.
If it is specified, the alarm EX2006 is displayed.
5.
For the machine equipped with a work rest (with workpiece unloading function), the
M631 (work rest extend by rotation) or M647 (work rest Y-axis bed side) command
cannot be specified when the tailstock is located in the negative region with respect
to the parameter setting value. If it is specified, the alarm EX2006 is displayed.
14-1-2
Releasing Tailstock Hard Overtravel
For the machine equipped with a work rest, the tailstock stroke in the negative direction is defined
with parameters. If the axis is moved beyond the stroke limit, the alarm OT 0507 occurs and the
axis is stopped.
<Releasing procedure>
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in either of the positions indicated below.
(ON)
(PANEL/EDIT)
4)
Select the manual mode.
5)
Move the axis in the direction opposite to the overtravel direction using handle feed, jog
feed, or rapid traverse operation.
6)
Press the
(RESET) key.
NOTE
