Ver
sion 1.0 D-GB
©
2009 Mor
ee Ltd.
Instruction Manual
Mod. Lounge LED Pro Accu 45 (07-09-04), 55 (07-09-01), 75 (07-09-02), 105 (07-09-03)
LOUNGE 45/55/75/105 LED PRO ACCU
•
Please read the instruction manual fully, before using the product.
Keep the manual for the entire life of the product.
•
If the product is stored for longer than 2 months,
make sure to charge it fully again.
www.moree.de
Moree Ltd.
Kaiserswerther Markt 11
40489 Düsseldorf
Germany
Designed in Germany © 2009 - Products are subject to change.
Distribution
Warranty
The vendor provides warranty for perfect material and error free
manufacturing for 12 months, starting from the day of purchase
on the following conditions:
The warranty is void with interference by the customer or through
a third party. Damage caused by inappropriate treatment, nat-
ural causes or causes beyond control do not fall under the war-
ranty. In response to complaints, we will replace/repair defect
parts or the whole product. Replaced parts will be retained. No
further claims exist due to the warranty. The warranty claim
needs to be proven with the purchase receipt by the customer.
IN THE CASE OF WARRANTY THE PRODUCT CAN ONLY BE
RETURNED AND ACCEPTED PROVIDING THAT IT IS IN ITS
ORIGINAL (INTACT) PACKAGING !
TROUBLESHOOTING
1) THE UNIT DOES NOT WORK
When the battery is empty
Solution: The product turns off automatically when the battery
is empty due to continuous use. It will turn itself back on when
the battery has been charged to a minimum level. This can take
approx. 1-3 hours to reach the minimum operating voltage.
Charge the product until the LED is lit green.
When one or both fuses are defect
Solution: Check fuses and replace if necessary. Make sure that
the charger is plugged into the product before plugging into the
mains (otherwise the fuse may blow). Keep product away from
moisture.
When the red light on the charger is not lit
Solution: Check the power supply, if the light on the charger is
still not lit, the charger is faulty.
When the charge is interrupted
Solution: Make sure the charger is correctly plugged into the
socket of the unit!
When the charge is to short
Solution: Charge the product until the LED is lit green.
2) THE REMOTE CONTROLLER DOES NOT WORK
a) The battery is empty or the batteries are inserted the wrong
way round (On/ Off button must be lit red).
b) Point the remote controller at the unit from different an-
gles.
c) Switch the LED product off or pull the plug to reset it.
3) THE REMOTE CONTROLLER IS BLOCKED
To set the correct code 11233, hold the ‘MAGIC’ button down un-
til the small light flashes twice. Enter the installation code ac-
cording to the table below (the small light lights up twice after
entering the correct installation code)
1 = VOLUME PLUS, 2 = VOLUME MINUS,
3 = CHANNEL PLUS, 4 = CHANNEL MINUS
If your product does not function any longer, then please first
examine if there is a problem with the power supply or if you
have handled the product incorrectly. If your product is defect in
any way, please contact the vendor.
•
Inclusive Remote Control and Charger
LED
Disposal/ Ecology
Packaging material and appliance are made from recyclable
materials. Seperation of the remaining waste materials into dif-
ferent types facilitates the recycling of valuable raw materials.
When the appliance is to be no longer used please dispose of
the appliance in the proper manner.
This Symbol on the product indicates that it should not be
disposed in the normal houshold waste. Please take it to
a recycling point for electrical and electronic appliances
to be recycled in a proper manner.
Rechargeable batteries which are dead or defective should not
be disposed of in the household rubbish; always take them to a
special waste disposal and make an important contribution to
protecting our environment.
Please obtain information on disposal from your local
authority.
