6
Rev. 1.0
09/06/2015
MSSTB-R/C Hardware Manual
400-820-9661
2 Getting Started
The following items are needed:
•
A 24-48VDC power supply (24-70VDC power supply for MSSTB10), see the section below
entitled
“
Choose a Power Supply
”
for help in choosing the right one.
•
A compatible stepper motor, please see the section below entitled
“
Recommended Motor
”
•
A small
fl
at blade screwdriver for tightening the connectors screw(included)
•
A PC running Microsoft Windows XP / Vista / Windows 7/ Windows 8(32-bit or 64-bit)operation
system
•
Install
STB Configurator
software (Available from MOONS
’
website)
•
-R model
For MSSTB05-R drive, a RS-485 daisy chain communication cable is included in the package.
It is used for connection with the next drive in the RS-485 network. It can also be used for
connection with PC for drive con
fi
guration.
For MSSTB10-R drive, a network cable is included in the package. It is used for connection
with the next drive in the RS-485 network. It can also be used for connection with PC for drive
con
fi
guration.
•
-C model
A RS-232 programming cable(included in the package)
For MSSTB05-C drive, a CANopen daisy chain communication cable is included in the
package. It is used for connection with the next drive in the CANopen network.
For MSSTB10-C drive, a network cable is included in the package. It is used for connection
with the next drive in the CANopen network.
TIP: When connecting the first drive in the RS-485 or CANopen network with PC or controller. you
can cut the daisy chain cable or network cable into two: one half is used for connection with the
RS-485 or CANopen port on the PC or controller, the other half can be used for connection with
termination resistor, which can be put at the end of the network.
