TXM
TXM24-S/Q Quick Setup Guide
Requirements
To begin, make sure you have the following equipment:
•
A small flat blade screwdriver for tightening the connectors (included).
•
A 12-70V DC power supply.
•
A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit) and Windows 8.
•
Step-Servo Quick Tuner software (available at www.applied-motion.com/products/software).
•
A 3004-277-5M power cable, 3004-290-5M I/O cable (optional), and for RS-232 models: 3004-278-5M RS-232
programming cable.
• NOTE: The 3004-278-5M Programming Cable is NOT included and must be purchased separately.
For RS-485 models: an RS-422 or RS-485 port or adapter for your PC (see reverse for recommended RS-485
adapter)
•
For more detailed information, please download and read the TXM24 Hardware Manual, available at www.applied-
motion.com/support/manuals.
Step1
Step2
a)
Download and install the Step-Servo Quick Tuner software.
b)
Launch the software by clicking: Start / Programs / Applied Motion Products / Step-Servo Quick Tuner
c)
Select the correct COM port using the drop down list
d)
Connect the drive to your PC using the RS-232 programming cable or RS-422/485 adaptor
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note - the TXM24 accepts DC voltages from 12-70V. If using an external
fuse, we recommend a 5 amp fast acting fuse.
(See the TXM24 Hardware Manual for more information about power
supply and fuse selection.)
Connect I/O, if required by your application. A 3004-290-5M cable will be
required.
(See the TXM24 Hardware Manual for more information about wiring I/O
to the TXM24.)
GND
EMI Filter
AC
Power
Input
LINE
LOAD
L
N
N
L
V+
V-
P/N:092.00823.00 (LCR)
4
3
1
2
POWER
DC POWER
SUPPLY
V-
V+
V+
V-
GND
920-0092 Rev C