Thank you for purchasing Moonrays
low voltage landscape lighting
products
#95565
. Please read all instructions carefully before installing.
Included in this box is one low voltage light.
ASSEMBLE THE FIXTURE HEADS
The low voltage light fixtures are shipped
pre-wired and partially assembled.
CONNECT THE FIXTURES
Connect the fixtures to the landscape
wire by following these simple steps.
Place one connector on each side of
cable, then press together to lock.
Prongs will pierce cable to make
contact and illuminate fixture.
After installation of fixture heads is
complete, plug in the control unit to
ensure that the lights come on. The
control unit is designed to light the
fixtures for 30 seconds after power is
applied.
NOTE: Make certain to
cover the photocell in order for the
lights to come on.
TROUBLESHOOTING
To reduce the risk of injury, unplug transformer and allow
fixtures to cool before attempting to troubleshoot.
If all of the fixtures do not light up:
Make certain that control unit is plugged in and working
properly.
If only some of the lights do not light up:
Make certain that the bulb is not burned out
Make certain that the wire on the fixture and the landscape wire
are making good contact in the connector box.
MAINTENANCE
Low Voltage landscape lights require very little
maintenance. To clean, was with a soft, damp cloth.
ADDING FIXTURES TO YOUR SET
You can add more lights to your set: the quantity being
dependent on the wattage of your control unit. To calculate
the total wattage of lights, add up the bulb wattages for each
fixture. The total must not be greater than the wattage rating
of the control unit. Note that lamp brightness of the fixtures will
decrease as you increase the distance from the control unit,
due to voltage loss.
If you need additional assistance, please do not return this to the place of purchase.
Contact Moonrays Consumer Relations at www.moonrays.com or 1-800-561-4321
RUN THE LANDSCAPE WIRE and
INSTALL THE CONTROL UNIT
Lay down your low voltage cable to
its full length in the desired location.
Excess cable may be cut off. Do
not run the landscape wire within
10ft of a pool, spa, or fountain. After
installation is complete, you may
bury the low voltage cable or hide
under mulch or stone.
The low
voltage unit cable and main low
voltage cable is intended for
shallow burial
– less than 6 inches
(152mm).
Follow directions that came with
your control unit for proper
installation.
After attaching the last
fixture, wrap the end of
the landscape wire with
electrical tape.
IMPORTANT SAFETY INFORMATION
• Do not install within 10 feet of water sources like a pool, spa or
fountain.
• Do not use the product with an extension cord.
• Do not overload the control box or exceed the maximum output
of the control box. Make certain that the total wattage of all
fixtures or equal to or less than the wattage of the control box.
• To reduce the risk of injury, unplug transformer and allow
fixtures to cool before attempting to troubleshoot or replace
bulbs.
• Do not install fixtures near things that may burn or catch fire.
• Control box should only be used with 12 volt low voltage
landscape lighting. Not for use in other applications.
• There are no replacement parts for the control box. Do not
disassemble.
• The control box should only be plugged into a GFCI protected
outlet.
• For use with landscape lighting systems only, outdoor use only.
• “THIS DEVICE IS ACCEPTED AS A COMPONENT OF A
LANDSCAPE LIGHTING SYSTEM WHERE THE SUITABILITY
OF THE COMBINATION SHALL BE DETERMINED BY CSA OR
LOCAL INSPECTION AUTHORITIES HAVING JURISDICTION.”
•
WARNING
– Risk of electrical shock. Install all luminaires
10 ft (3.05m) or more from a pool, spa or fountain.
• Main low voltage cable and control box are not included. You
may order additional lengths of main low voltage cable at your
local hardware store or many online retailers.
