Mooney M20TN S type, Руководство по эксплуатации для пилотов

Страница: 231 / 266

MOONEY
M20TN - MODEL TYPE-S
SECTION VII
AIRPLANE AND SYSTEM DESCRIPTION
7 -- 31
AIRPLANE FLIGHT MANUAL ORIGINAL ISSUE -- 04-02-2008
MAP LIGHT
Map lights are installed on the bottom of the pilot and co--pilot’s wheel. These lights are turned on
when the INSTRUMENT light control on the panel is turned on. The intensity of the map light may
be adjusted with the MAP LITE knob located (while facing the wheel) on the right aft side of the
pilot’s and co--pilot’s control wheel.
CABIN LIGHTING
Overhead lights illuminate the cabin. All passenger overhead lights are controlled by a POWER
LITES switch located on the pilot’s arm rest. With Master Light Switch ON, individual overhead
cabin lights are controlled by rocker switches located on each passenger’s arm rest (excluding
front seat passenger). Front seat passenger’s light switch is located forward of cabin door hinge
on side panel.
--CAUTION--
The Cabin Light rocker switches are connected directly to the battery. Leaving the
POWER LITES switch on indefinitely when the engine is shutdown will run down the
batteries.
EXTERIOR LIGHTING
Conventional navigation and high intensity strobe lights are installed on the wing tips and on the
rudder trailing edge (strobe light only). Landing and Taxi lights are installed in the right and left
wing leading edge. Split switches are used to control either the left or right taxi or landing lights.
All exterior light switches are located on overhead panel just behind top of windshield.
The high intensity wing tip and tail strobe lights are required for night operation but should be
turned OFF when taxiing near other aircraft or flying in fog or clouds. The conventional position
lights must be used for all night operations.