CONTENTS:
HOW TO MOUNT THE HEADLIGHT
RS-A
RS-B
BEAM ADJUSTMENT
To adjust the horizontal beam, spin the headlight left to right for your
best side to side beam angle. To adjust the vertical beam angle,
loosen the mounting and rotate the light up and down to your best
vertical beam angle, then tighten the mounting.
The beam is widely dispersed, besides its high brightness. To prevent
from blinding the oncoming vehicles on the public roads, you’d better
adjust the angle downward.
!
USER GUIDELINE
Thank you for choosing MOON LUXEIUM series headlight!
*For using this product safely and conveniently and keeping it
well-preserved, please read this manual carefully before using.
Please save this manual for future reference.
*Due to the improvement of the product, the product you bought may
not be exactly in accordance with the introduction of this manual. We
apologize for that.
SPECIFICATION
CONTECTS INCLUDED
1. Choose the strap to fit in the bar.
2. Make sure the strap is click in place of the hook.
3. Hold the light on the handle bar.
4. Wrapping rubber strap around bar and stretching strap around hook to secure.
*1 pc CREE XP-E LED
*Rechargeable lithium polymer battery ( 3.7V 550mAh)
*USB rechargeable
*Water resistant headlight with durable aluminum alloy body
*6 modes : Over drive / High / Standard / Flashing / Strobe / SOS
*Quick release handlebar mount (fits 20-40mm)
*Low battery, charging and fully charged indicator
*Automatic fully charged cut-off system
*High precision optical lens
* LX-100
* Lithium polymer battery
* USB cable
* Handlebar rubber strap
* Rubber base
1. Press the power button to choose the modes:
In this method three modes are cycle.
LIGHT OPERATION
2. Fast press two times the power button to change into the strobe
and flashing modes.Fast press two times back to the first cycle.
3. Press and hold the on / off button around 0.5 second to turn off.
PRESS
Hold 0.5 sec
Power button
PRESS
Over drive
High beam
Standard
Over drive
High beam
Standard
Flashing
Strobe
SOS
Fast press
2 times
Fast press
2 times
WRAPPING
Power button
Rubber strap
Base cover
USB cover
27 - 40 mm
20 - 25 mm
1.
2.
3.
Power button
Power button
®
Battery installation
1. Do not up side down the slot.
2. Align the slot until it clicks into place.
3. Fold up the battery install into the light.
4. Twist the remain wire into the light of the remain sapce.
5.Twist the screw clockwise until install the base cover.
Battery release
1.Twist the screw anti-clockwise until release the base cover & rubber pad.
2.Use two finger to hold the light body when release the battery from the
light.
INSTALL THE BATTERY
THE BATTERY REPLACEMENT
RELEASE
RELEASE
Battery
Hold
Hold
RELEASE
Battery
UPSIDE DOWN
Hold
Hold
ALIGN
INSTALL
INSTALL
(Make sure the strap is click in place of the hook.)
