Moomba Gravity Edition, Руководство пользователя

Страница: 36 / 88

36
© 2009 Skier’s Choice, Inc.
Please refer to your stereo owner’s manual for proper operation
instruction.
NOTE: Stereo unit is connected to the STEREO switch on the
dash. The ACC switch must be in the “ON” position before
the stereo can be turned on.
The stereo cannot be turned off by the remote. The “SRC”
button on the stereo unit must be held down for three seconds
to completely turn the stereo off. Continue to hold the SRC
button until display goes blank or turn off the ACC switch on
the dash..
If the face displays “ALL OFF”, your stereo is in standby mode
and drawing battery power which will drain the battery and
may lead to a dead battery.
Stereo
Accelerate the boat up to the desired cruising speed.
Engage the EZ Cruise System by moving the rocker switch
from “OFF” to “SET”. At this point the cruise system will take
over throttle control and maintain the RPM at which it was
set. The small red LED light will come on to let the operator
know that the system is engaged. The red LED light will
remain on until the system is turned “OFF” using the rocker
switch.
1.
2.
EZ Cruise - Activating The Cruise System
The system will not allow any more throttle input than the
position of the throttle arm. Therefore, the throttle arm
should be advanced completely after the initial engagement
of the system to allow the system to maintain the set RPM
with different throttle positions required such as when the
boat turns.
NOTE: If the engine is turned off and the cruise system is
left on, when the engine is restarted, the operator will have
no throttle control, because the cruise system will engage
at the idle RPM.
Adjusting The Boat Speed
The speed of the boat can be adjusted faster by pressing and
holding the “+” side of the momentary rocker switch, which
will increase the engine RPMs relative to the throttle position,
therefore to go faster than the initial set point.
The speed of the boat can be adjusted slower by pressing
and holding the “-” side of the momentary rocker switch,
which will decrease the engine RPMs. The engine will
decrease RPMs below the initial set point.
Throttle override. After the handle has been released and
not moved for more than 2 seconds, throttle override is
available. To operate the throttle override, simply move the
throttle more than 20% and you can apply more throttle. To
reengage the system, slightly back the throttle down until
light first begins to blink. Then slightly move the throttle
forward until the light returns solid red and the system will
be reengaged.
Disengaging The System
The EZ Cruise System will disengage throttle control when the
throttle is brought back below the current RPM set position
at that time. IF the engine RPM has been changed using
the “+” or “-” momentary rocker switch during operation, the
latest RPM position is the point where the cruise system will
disengage throttle control once the throttle position is lower
than that relative RPM position. The system will reengage
once the throttle position is advanced back above the last set
RPM position, as long as the motor was not turned off.
The system can be completely disengaged by turning the
system “OFF” using the rocker switch. If this is done while
the boat is at speed and the system is engaged, the throttle
will have to be moved below the set RPM position before it
will completely disengage and allow the operator complete
throttle control.
3.
1.
2.
3.
1.
2.