Moog G396-026, Руководство по эксплуатации

Страница: 10 / 85

Programmable Multi-Axis Servo Drive Power Supply Unit Operation Manual
ID no.: CA97556-001 Date: 03/2015
moog
10
Safety
Commissioning (i.e. putting the device to its intended use) is only permitted in
compliance with the EMC Directive (2004/108/EC).
The Power Supply Unit conforms to the Low Voltage Directive 2006/95/EC.
The Power Supply Unit conforms to the requirements of the harmonised product
standard IEC/EN 61800-5-1.
If the Power Supply Unit is used for special applications (e.g. in areas subject to explosion
hazard), the required standards and regulations (e.g. IEC/EN 60079-0: "Explosive
atmospheres - Part 0: Equipment - General requirements" and IEC/EN 60079-1:
"Explosive atmospheres - Part 1: Equipment protection by flameproof enclosures‚d’ “)
must always be observed.
Repairs may only be carried out by authorised repair workshops. Unauthorised opening
and incorrect intervention could lead to death, physical injury or material damage. The
warranty provided by Moog would thereby be rendered void.
NOTE:
Deployment of the Power Supply Unit in non-stationary equipment is classed
as non-standard ambient conditions, and is permissible only by special
agreement.
1.3 Usage contrary to intended use
The Power Supply Unit must not be used:
y without the mains connection set (filters, chokes)
y outside a switch cabinet
y in a photovoltaic system
y with a directly connected DC motor
y in island mode
1.1.2 Warning symbols used
The safety instructions detail the following hazard classes. The hazard class defines the
risk posed by failing to comply with the safety notice.
Warning symbols General explanation Hazard class to ANSI Z 535
!
ATTENTION!
Misoperation may result in damage to
the drive or malfunctions.
Serious injury or damage to property may
occur.
DANGER FROM ELECTRICAL
TENSION!
Improper behaviour may endanger
human life.
Death or serious injury will occur.
Table 1.2 Explanations of warning symbols
1.2 Intended use
The Power Supply Unit is intended for use in a Multi-Axis Servo Drive System. The multi-
axis system comprises a Power Supply Unit with the mains connection set and a number
of Multi-Axis Servo Drives connected to it. In motorised mode, the Power Supply Unit
draws power from the supply system and makes it available to the connected Multi-Axis
Servo Drives via the DC link. In regenerative mode the power is stored in the DC link.
Temporarily surplus energy is fed back into the supply network by the Power Supply Unit
in sinusoidal form.
The Power Supply Unit additionally performs the function of a reactive power
compensator as required. (For details please consult your project engineer.)
The Power Supply Unit is a component intended for installation in stationary electrical
systems or machines.
When installed in machines the commissioning of the servo drive (i.e. start-up of
intended operation) is prohibited, unless it has been ascertained that the machine fully
complies with the provisions of the Machinery Directive 2006/42/EC; compliance with
IEC/EN 60204 is mandatory.