Model 914-X Series Modular Multiplexer System User Manual
Focal Technologies Corporation
Page 7-6
A Moog Inc. Company
Document Number: 914-0601-00
Rev.
5.0
Table 7-5: SW7 - DIAGNOSTICS IN MSA OR NON-MSA
Function
SW7[1]
SW7[2]
SW7[3]
SW7[4]
Diagnostics Mode (
default
)
OFF
OFF
OFF
N/A
Non-MSA Mode (
default
)
N/A
N/A
N/A
OFF
MSA Mode
N/A
N/A
N/A
ON
Table 7-6: SW2 (Channel 1) and SW6 (Channel 2): Input EQ or Output Cabled Driver Settings
Function
SWx[1]
SWx[2]
SWx[3]
SWx[4]
Video Output CD Mode
OFF
(
CONSOLE
)
N/A
N/A
N/A
Video Input EQ Mode
ON
(
REMOTE
)
N/A
N/A
N/A
EQ Gain Normal
N/A
OFF
(
DEFAULT
)
N/A
N/A
EQ Gain Boost 6dB
N/A
ON
N/A
N/A
EQ Enabled
N/A
N/A
OFF
(
DEFAULT
)
N/A
EQ Bypass
N/A
N/A
ON
N/A
Cable driver in SD Mode
N/A
N/A
N/A
OFF
Cable driver in HD Mode (console)
N/A
N/A
N/A
ON
(
DEFAULT
)
7.1.5 914-HDV2 Diagnostic LED Header
The 914-HDV2 card includes a 10-pin header capable of driving 8 LEDs. This is useful for LED integration into an
enclosure. Each LED pin is driven low to turn on an LED, and includes a 267 ohm resistor in series to limit the
current draw. Maximum current draw is 8 mA.
The LED header is FCI P/N 20021521-00010T1LF, and the mating part is FCI P/N 20021444-00010T1LF. This can
be used with most 0.050” (1.27mm) spacing ribbon cables.
Table 7-7: 914-HDV2 Diagnostic LED Header J7 Pinout
J7 Pin
Name
Description
1
3.3V
3.3V
This pin can be used to drive the LEDs, Maximum current is 0.5A.
2
RX OPT LINK
Receive Optical Link Valid (MSA SFP only). Active low.
3
VID CH1 CD
Video Channel 1 Carrier Detect. Remote side only. Active low.
4
VID CH2 CD
Video Channel 2 Carrier Detect. Remote side only. Active low.
5
FAULT
Fault. (no SFP, No I2C diagnostics) Active low.
6
RX OPT LINK CH2
Receive Channel 2 Optical Link Valid (non-MSA SFP only). Active low.
7
RX OPT LINK CH1
Receive Channel 1 Optical Link Valid (non-MSA SFP only). Active low.
8
VID CH1 VALID
Video Channel 1 output is valid. Console only. Active low.
9
VID CH2 VALID
Video Channel 2 output is valid. Console only. Active low.
10
GND
Ground
