Montigo RXM40VACVO, Инструкция по установке и обслуживанию

Страница: 4 / 6

XG0680 - 080321 4
General
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to
press the LEARN button on the receiver to accept the transmitter security
code upon initial use, if batteries are replaced, or if a replacement
transmitter is purchased from your dealer or the factory. In order for
the receiver to accept the transmitter security code, be sure the slide
button on the receiver is in the REMOTE position; the receiver will
not LEARN if the slide switch is in the ON or OFF position. The LEARN
button in located on the front face of the receiver; inside the small hole
labeled LEARN. Using a small screwdriver or end of a paperclip gently
Press and Release the black LEARN button inside the hole. When you
release the LEARN button the receiver will emit an audible “beep”. After
the receiver emits the beep press any transmitter button and release.
The receiver will emit several beeps indicating that the transmitter’s
code has been accepted into the receiver.
To delete all of the transmitter codes on your receiver, press and hold
the LEARN button for 10 seconds. Then you will hear a series of beeps,
indicating that the receiver’s memory has been cleared.
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter should be
at least 12 months.
Check and replace all batteries:
• Annually.
• When operating range becomes reduced.
• When transmissions are not received by the remote receiver.
• If the hand held transmitter battery measures less than 9.0 volts.
TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem
may be with the fireplace itself or it could be with the remote. Review
the fireplace manufacturer’s manual to make sure all connections
are made properly. Then check the operation of this remote in the
following manner:
• Make sure there is a 110-volt power source to the receiver.
• Check battery in transmitter to make sure contacts are touching
(+) and (-) ends of battery. Bend metal contacts in for a tighter fit.
• Check if the transmitter battery is fully charged.
• Ensure that the transmitter and receiver are within 20 to 25-foot
operating range.
• If the receiver is installed in a tight enclosed metal surrounding, the
operating range will be shortened.
• Make sure the hand-held transmitter and remote receiver are
communicating properly (see LEARNING TRANSMITTER TO RECEIVER
section).