Montigo Prodigy PC3 Series, Инструкция по установке и обслуживанию

Страница: 24 / 36

24
Operation
XG0799 - 081319
LED Remote Control Operation
# Mode
Brightness
State
Speed
State
1 Static white color Adjustable Unadjustable
2 White color gradual changes Adjustable Adjustable
3 All colors gradual change Adjustable Adjustable
4
Red/green/ blue three colors
gradual change
Adjustable Adjustable
5 Seven colors jump to change Adjustable Adjustable
6 Three colors jump to change Adjustable Adjustable
7 Red/ green jumps to change Adjustable Adjustable
8 Red/blue jumps to change Adjustable Adjustable
9 Blue/green jumps to change Adjustable Adjustable
10 White color frequently blinks Adjustable Adjustable
11 White color glitters Adjustable Adjustable
12 Red color frequently blinks Adjustable Adjustable
13 Red color glitters Adjustable Adjustable
14 Green color frequently blinks Adjustable Adjustable
15 Green color glitters Adjustable Adjustable
16 Blue color frequently blinks Adjustable Adjustable
17 Blue color glitters Adjustable Adjustable
18 Yellow color frequently blinks Adjustable Adjustable
19 Yellow color glitters Adjustable Adjustable
20 Circulation mode
Item Parameters
Working Voltage AAA*2pcs(3V)
Radio Frequency 2400-2483.5MHz
Modulate Method GFSK
Transmit Power 6db
Standby Power Consumption 10uA
Remote Distance 20-30m
Dimension 110×52×30mm
Figure 30. LED remote
Figure 30.b Remote parameters
Figure 30.c Remote modes
Montigo’s series fireplaces have integrated LED lighting installed
beneath the burner tray. The LEDs are controlled by the included
remote. The fireplace burner does not need to be lit for the LEDs to
function.
The LEDs can be set to any solid color using the color wheel on
the remote control, or to any of the 20 patterns listed below. The
speed and brightness of the various functions can also be adjusted
by the remote.
LED Troubleshooting
The LEDs are pre-wired inside the control panel and fireplace;
ensure that all wiring is connected before troubleshooting.
If the LEDs are lit but cannot be controlled by the remote, first
change the remote’s batteries.
If the remote still cannot control the LED lighting, you may need to
pair the remote with the controller.
If the LEDs will not light, measure the voltage on the power
supply’s output (underneath burner tray), the output should be
24VDC.
If a portion of the LED strip displays a single color only, the LEDs
must be replaced.