33
Operation
XG0229 - 112718
Battery operated device.
Read the battery instructions before
installing them into the system. Do not expose any battery, or its
holder, or a device in which batteries are installed, to a working
temperature greater than 54°C / 129°F
Initializing the System for the first time
1. Set master override switch to off position.
2. Install four (4) AA batteries into the battery holder.
3. Install three (3) AAA batteries in the back of the remote
control. Note the polarity of batteries and install them as
indicated by the silk screen (+/-) on the holder.
4. Connect AC Power (115 volts, 60 Hz) to fireplace.
Operating the System for the first time
Press SW1 button on the control module. The control module will
beep three (3) times and an amber LED is illuminated to indicate
that the IFC (control board) is ready to synchronize with a remote
control within 10 sec. Push the ON button. The control module
will "beep" four (4) times to indicate transmitter's command is
accepted.
The System is now initialized.
Temperature Indication Display
With the system in the "Off" position, press the Thermostat Key
and the Mode Key at the same time. Look at the LCD screen on
the Remote Control to verify that a C or F is visible to the right of
the Room Temperature display.
Turn On the Fireplace
With the system Off, turn the master override switch to on and
press the On/Off Key on the Remote Control. The Remote Control
display will show some other active Icons on the screen. At the
same time the Control Module will activate the fireplace. A single
"beep" from the Control Module will confirm reception of the
command.
Turn Off the Fireplace
With the system On, press the On/Off Key on the Remote
Control. The Remote Control LCD display will only show the
room temperature. At the same time the Control Module will
turn off the fireplace. A single "beep" from the Receiver confirms
reception of the command.
Figure 27.d
Remote Control Battery Compartment
Figure 27.e
Remote Control display in Fahrenheit & Celsius
Figure 27.f
Remote Control Display
WARNING
