Waldorf Rocker Assembly Instructions
Thank you for purchasing a Waldorf Rocker from us. We hope these instructions will help you
assemble it quickly and properly. Please follow along so that it is safe to use. If at any point you
have questions or seem to be missing a part, please contact us.
WARNING:
As can be considered a climbing apparatus, please be aware that injuries can
occur. Make sure that the rocker seems safe to use and is sturdy. Also make sure that while it is
in use that you observe your child at all times while using it, and that the area is safe. Do not
place it near hard edges such as fireplace mantles or stairs. A mat underneath would be
advised. Contact us if the product seems unsafe or if there are any questions.
1. Please check that all parts were shipped. There should be:
● 2 large sides of the rocker
● 8 slats
● 36 flat head screws, 1.25” long, shiney bronze in colour
● One bottle of glue
2. You will need either a #2 robertson (square) screw driver or a drill with the #2 robertson bit.
Be careful using a drill to put the screws in as you may over tighten them. If you do, they may
strip the hole and spin in place. If this happens, they will not be securing the two pieces
together. Also a mild damp rag or wet wipes may come in handy.
3. Setup the sides of the rocker on a large table or flat floor. A large flat area will be needed to
make sure the sides are flat and parallel. All the slats are interchangeable, and can be used in
any position.
4. Go slat by slat. Place a bead of glue in the groove. Do not put too much in it as it will
squeeze out and make a mess. If glue squeezes out, use a mildly damp cloth or wet
wipe. Match the corresponding number on the side with the number on the slat and
push it into the groove. Use your drill or screwdriver to screw in the two screws. Again,
please be careful if using a drill to put the screws in. It can either split the wood or strip
the screw in the hole Work your way along one side.
