Loosen set screws with locking nuts and
remove keeper from pin and then pin from
yoke for downrod (see inset).
Install downrod with canopy and yoke covers
into yoke. Align hole in downrod and yoke,
push pin through and replace keeper. Tighten
set screws and locking nuts (see inset).
Hang assembled fan from the mounting bracket
installed to ceiling in previous steps. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
Install downrod to canopy and then install yoke
cover to downrod. Thread wires and safety
cable through downrod
5
6
8
4
Make wire connections to power source using wire
nuts provided. Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet
box.
11
Check the motor for plastic shipping sta-
bilizer tabs and remove them if they are
present.
7
Remove the 3 screws in round holes.
Remove cap by twisting and pulling
down. Save screws.
15
Attach blade brackets to blades
using the blade bracket screws
and washers provided.
13
The screws, washers, and motor
pads are pre-installed to the blade
holders. Attach blade assembly to
motor and tighten screws securely.
14
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house.
Refer to Safety Tips section of
manual.
10
House
Fan
Blue
Black
White
Green
Black
White
Ground
Loosen one and remove one pre-
assembled screw from mounting
bracket. Save screw. Lift canopy up,
aligning its keyhole slot with the pre-
assembled screw on mounting
bracket and twist clockwise to lock in
place. Re-install the removed screw
and tighten all screws securely.
12
