Monte Carlo Fan Company 5LLR56, Руководство пользователя и инструкция по установке

Страница: 5 / 11

5
© 2014 Monte Carlo Fan Company
10/1/2014
11 12 13
14 15
16
Partially loosen 2 of the set screws on
mounting bracket corresponding to the
slotted holes on the canopy upper ring.
Remove the other 2 set screws. Save
screws.
Remove every other screws (the screws
located at round holes) from yoke located
on top of fan assembly. Keep screws.
Remove canopy bottom cap from canopy.
Note
: Flush mount is not available with
vaulted ceiling.
Place canopy over lead wire and safety
cable and align the larger holes in canopy
with the set screws on yoke.
Reinstall the 3 set screws remove in step
13. Tighten screws securely.
To prepare the fan for wiring, hang fan
onto mounting bracket by sliding the
canopy over the mounting bracket hook
( Use one of non-slotted holes on the
rim of the canopy ).
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 1.5” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Raise canopy to mounting bracket,
aligning loosened screws in mounting
bracket with slotted holes in canopy.
Twist canopy to lock. Reinstall the screws
removed in step 11 and tighten all
screws securely.
Go to step 20 to finish installation
Mounting bracket
Flush Mount Installation
Canopy
Canopy
Canopy bottom cap
Mounting bracket
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer