7
EDID MANAGEMENT
The EDID® system tells the source device the maximum capabilities of any
connected display(s). You can set the EDID to the capabilities of the display
connected to the receiver, a display connected to the transmitter's loop-out
port, or a default of 1080p with stereo audio, if no display is connected to the
transmitter. Perform one of the following steps to set the EDID.
•
Momentarily press the EDID button on the transmitter to get the EDID
from the display connected to the receiver.
•
Press and hold the EDID button for 3 seconds to get the EDID from the
display connected to the transmitter's loop-out port. If no display is
connected to the transmitter's loop-out port, it will get the internal EDID
of 1080p video with stereo audio instead.
REGULATORY COMPLIANCE
Notice for FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Modifying the equipment without Monoprice's authorization may result in the
equipment no longer complying with FCC requirements for Class B digital
devices. In that event, your right to use the equipment may be limited by FCC
regulations, and you may be required to correct any interference to radio or
television communications at your own expense.
