Information to Users
This equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING:
RF EXPOSURE WARNING:
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance
of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure
compliance, operations at closer than this distance are not recommended. The antenna used for this transmitter must not be
co-located in conjunction with any other antenna or transmitter.
Monnit Wireless Sensors &
MonnitLink
™
CGW2 Cellular
Gateway User’s Guide
WARNING:
!"
DO NOT REMOVE THE SIM
CARD!
"# !"$
%$ # !"%
"# !"$
Inside the Box
!
"#$
™
"
MonnitLink
™
CGW2 Cellular Gateway
%&&'
(
