Compact Hopper Test Box Instructions TSP063doc Issue 2.1 – June 2004
©
Money Controls 2004. All rights reserved.
Page 9 of 11
4.3
PULSE / FREE
Switch on the power supply.
The display will show the following:-
The left hand side of the display (COUNTER) shows how many coins have been paid out
while the right hand side (CURRENT) shows the current being drawn by the hopper.
Switch “HOPPER / ON” to “ON” to start the hopper paying out coins.
The display will show the following:-
As each coin is paid out, the counter will increment by 1, the “OPTO” LED will flash and
the motor will pause for 500ms (
Pulsed Mode
) before starting again and paying out the
next coin
.
The hopper will continue to run even when all the coins are paid out.
To stop the hopper, switch “HOPPER / ON” to “HOPPER”.
The display will show:-
To repeat, switch “HOPPER / ON” to “ON” to start the hopper paying out coins again.
Note:- Should the opto become blocked while paying out in PULSED mode, the disk
will continue to move around very, very slowly.
