Installation and Operating Instructions Balance
5
Stacking of the stones
The heater stones should be stacked so that the resistors remain in
a straight line. The resistors should never be bent so that they would
touch the metal structures of the heater.
The resistors should be surrounded by stones on all sides. Do the
stacking in layers starting from the bottom.
Fill the stone compartment with stones until you reach the upper
level. Until 10 cm from the bottom the stones should be placed not
too close to each other, this to ensure good ventilation. By doing
so the sauna heating time will also get shorter than otherwise.
Continue the stacking of the stones in this way until all stones
have been placed.
note! the resistor may not touch the heater’s metal structure
anywhere, there always needs to be a stone in between.
Do not stack stones above in the picture below marked ventilation
hole, because it will prevent the ventilation of the heater!
When stacking the stones, please do not batter on the heater’s metal
surfaces in order to avoid damage. Dents caused by the user are not
covered by the manufacturer’s warranty or other product liability.