Installation and Operating Instructions Balance
12
Installation of the external control and sensor
Drill a 3,5 mm hole to the panel and then bring it to the wiring
panel. The sensor should remain visible for ca 10 mm. When
needed, the sensor can be fixed into the hole, for instance with a
small drop of silicone adhesive. The sensor cable measures 6 m.
Cut the excess wire and connect the other end to the heater.
The wall mounting plate is either mounted with three screws to
the wall or fixed to the bottom of the mounting box. The mount-
ing plate is covered with a cover plate and finally with the control
panel. The mounting cable is 8 m. Cut the extra cable and
connect the other end to the heater. When installing the control
panel, make sure that the cables are not detached or deformed.
note! Remove the plastic protection foil of the control panel before
using the heater.
E-type heater includes:
External control
Sensor