4
Pulse output
5.0 PREPARATION FOR MEASUREMENT
5.1 Noncontact Preparation
Follow the steps below for internal operation (red laser) or external
operation using optional Remote Optical Sensor (ROS-Red LED):
1.
Clean shaft.
As small as 1/8
"
wide on
side or radius edge
2.
Apply 1/2
"
square
of T-5 Reflective tape.
For small shafts:
5.2 Direct Contact Preparation
Follow external operation ONLY using optional Remote Contact
Assembly (RCA):
Select and install contact option:
1.
Contact Tip (convex tip shown)
Use concave tip for small shafts
Align flats
Tighten screw securely
into flat on shaft
2.
10 cm Wheel
3.
12 in. Wheel
OR
Install with pin in
shaft fully seated in
slot; tighten screw
