18
5.4.2 UNITS Menu
This menu option selects the Engineering Units used to display the
flash rate or speed. The choices are:
FPM
Flashes per Minute (not available in TACH Mode)
FPS
Flashes per Second (same as Hz; not available in TACH Mode)
RPM
Revolutions per Minute
RPS
Revolutions per Second (same as Hz)
Press the MENU button to enter the UNITS menu. Unit is shown
on the top line with the current engineering unit on the lower line.
The On-Target indicator will be on for the currently selected value.
Use the arrows on the joystick to select the desired value.
Press the MENU button followed by the Power button to save the
value.
To exit without setting the units, press the Power button .
5.4.3 INPUT Menu
This menu sets the pulse polarity of the external signal that will
trigger the strobe. The options are
nEG
for negative edge or
POS
for positive edge.
Press the MENU button to enter the INPUT menu. The current
edge setting is shown on the top line with INPUT on the lower
line. The On-Target indicator will be on for the currently selected
value.
Use the arrows on the joystick to select the desired value.
Press the MENU button followed by the Power button to save the
value.
To
exit without changing the polarity, press the Power button.
MENU button POWER button On-Target indicator Joystick arrows
MENU button POWER button On-Target indicator Joystick arrows
