8
4.1.3 Doubling or Halving the Flash Rate
Press the MENU button twice to display the x2 and ÷2 icons. Press
the POWER button to exit this mode.
To confirm that the strobe is flashing at the same rate that the
target is moving and that the RPM/RPS reading is accurate, use
the x2 button until you see a double or multiple image, then use
the ÷2 button until you see a single image. This will now be the
correct speed as shown in Figure 5 (next page).
4.1.2 Touch Keypad Entry
Press the MENU button to display the numeric keypad. The
flash rate will default to 0 and show the units you are entering.
Note that this is a capacitive touch sensitive keypad and will not
respond if the user is wearing gloves.
Press the MENU
button twice.
Use the joystick or touch
icons on display to x2 or ÷2.
Press the MENU button.
Enter the desired flash rate
and press the enter key .
MENU button POWER button On-Target indicator Joystick arrows
MENU button POWER button On-Target indicator Joystick arrows
