Monacor JTS RU-8011D/5, Инструкция по эксплуатации

Страница: 15 / 28

15
English
8.1 Function
(synchronizing receiver and transmitter)
The function allows you to transfer
settings from the receiver to the transmitter via
ultrasound The settings transferred depend on
how the function has been configured in the
menu (
☞ chapter 5 8)
Note:
On the two transmitters RU-850LTB / 5 and
RU-850LTH / 5, the settings can also be made via con-
trol buttons
Switch on the transmitter and place it at a dis-
tance of 20 – 80 cm (optimum distance: 30 cm)
from the receiver in such a way that the ultrasonic
sensor of the transmitter is vertical (±30°) to the
ultrasonic transmitter section
(1) When using
a hand-held microphone, screw off the sleeve
of the microphone until the ultrasonic sensor is
not covered any more Also see fig 3 on page 2
To start the transmission, press the button
(2) The luminous ring of the button
will flash rapidly while the settings are being
transferred Once the transmission has been com-
pleted, the ring will light continuously again If the
ring changes from rapid flashing to slow flashing,
the transmission has failed (To terminate flashing
after a failed transmission, briefly press one of the
other buttons )
9 Specifications
Carrier frequency range: . 506 – 542 MHz
Audio frequency range: . . 60 – 15 000 Hz
Output level / Impedance
XLR, bal .: . . . . . . . . . . . 630 mV/ 600 Ω,
63 mV/ 600 Ω (with 20 dB
attenuation)
6 .3 mm jack, unbal .: . . . 320 mV/ 600 Ω
THD: . . . . . . . . . . . . . . . . < 0,6 %
Dynamic range: . . . . . . . . > 105 dB
Interference suppression: . via pilot tone and adjustable
squelch function
Ambient temperature: . . . 0 – 40 °C
Power supply: . . . . . . . . . via power supply unit pro vided
and connected to 230 V / 50 Hz
Dimensions (W × H × D): 210 × 40 × 180 mm
(antennas folded)
Weight: . . . . . . . . . . . . . . 440 g
Subject to technical modification
AF
MUTE
RF
CH G
SET
SET
SET
SET
SET
SET
SET
SET
SET
2 s
A B
LOCK
AF
MUTE
RF
CH G
A B
LOCK
CH G
AF
MUTE
RF
A B
LOCK
CH G
AF
MUTE
RF
A B
LOCK
CH G
AF
MUTE
RF
A B
LOCK
CH G
AF
MUTE
RF
A B
LOCK
CH G
AF
MUTE
RF
AF
MUTE
RF
AF
MUTE
RF
SET
Channel
Scan function
Attenuation for the
XLR output
Squelch value
Audio sensitivity
of the transmitter
Automatic switch-off
of the transmitter
Transmission power
of the transmitter
REMOSET configuration
“Cancel”
Menu will be exited
Group
➃
Configuration menu
Radio frequency
All rights reserved by MONACOR ® INTERNATIONAL
GmbH & Co. KG. No part of this instruction manual
may be reproduced in any form or by any means for
any commercial use.