Hand Crimp Tool for MV-396™ Wire-to-Board Crimp Terminals
Doc No: ATS-638235900
Release Date: 08-26-10
UNCONTROLLED COPY
Page 6 of 7
Revision: C
Revision Date: 08-24-12
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will
not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing, or use of handle extensions voids this warranty.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS:
1.
Manually powered hand tools are intended for low volume or field repair. This tool is
NOT
intended for
production use. Repetitive use of this tool should be avoided.
2.
Insulated rubber handles are not protection against electrical shock.
3.
Wear eye protection at all times.
4.
Use only the Molex terminals specified for crimping with this tool.
Certification
Molex does not certify or re-certify hand tools but rather supplies the following guidelines for customers to re-certify
hand tools.
%
This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire, which has been stripped
12.7mm (1/2”) long, so there is no crimping of the insulation. Pull the terminal and wire at a rate no faster than
25mm (1.00”) per minute. See the Molex web site for the Quality Crimp Handbook for more information on pull
testing.
%
If the tool does not meet minimum pull force values, handle preload should be increased and the pull test
rerun, (See How to Adjust Preload).
%
When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service and
replaced.
