CR5905 Hand Crimp Tool
Doc No. 11-01-0195
Release Date: 04-13-93
UNCONTROLLED COPY
Page 1 of 4
Revision: C
Revision Date: 07-28-04
INSULATION
CRIMP
BRUSH
STRIP
LENGTH
BELL MOUTH
CRIMP HEIGHT
BEND
DOWN
BEND UP
ROLLING
CONDUCTOR
CRIMP
TWISTING
HAND CRIMP TOOL
Operating Instruction and
Specification Sheet
Order No. 11-01-0195 (CR5905)
FEATURES
Small handle spread which make this style tool ideally suited for end users
Ratchet with safety release that ensures consistent performance
A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position
SCOPE
Wire Size
Insulation Diameter
Strip Length
Terminal
Series No.
AWG
mm² mm In. mm In.
5230 22
-
30 0.35-0.05 1.10-1.50 .043-.060 2.54-3.17 .100-.125
DEFINITION OF TERMS
The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope.
CONDITIONS:
After crimping, the conductor profiles should measure the following (see notes on page 3).
Punch Width (Ref)
Wire Size
Cond. Crimp
Height (Ref)
Cond. Ins.
Pull Force Min. Profile
Terminal
Series No.
AWG mm
2
mm
In. mm In. mm In. N Lb. A B
5230
22 0.35 0.80-0.90 .031-.035 1.22 .048 1.30 .051 44.5 10.00 X
5230
24 0.20 0.78-0.88 .031-.035 1.22 .048 1.30 .051 28.9 6.50 X
5230
26 0.12 0.71-0.81 .028-.032 1.22 .048 1.30 .051 17.8 4.00 X
5230
28 0.08 0.69-0.79 .027-.031 1.22 .048 1.30 .051 11.1 2.50 X
5230
30 0.05 0.68-0.78 .027-.031 1.22 .048 1.30 .051 6.7 1.50 X
