2.50mm Pitch Floating Wire-to-Board Plug Crimp Terminal
Doc No: ATS-638255000
Release Date: 04-11-13
UNCONTROLLED COPY
Page 5 of 7
Revision: A
Revision Date: 04-11-13
MATCH
UP MARKS
FRONT
BACK
Figure 9
2.
Remove the M3 BHCS which is holding the upper
tooling.
3.
Flip the upper tooling to the opposite side and replace
the M3 BHCS. Make sure the small markings on the
front and back of the hand tool frame, match up and
are on the outside of the hand tool frame. See Figure
8 and 9.
4.
Do the same thing with the lower tooling and tighten
the M3 screws. Be sure the small markings line up.
5.
Reinstall the locator by following the Instructions in
the locator replacement section.
Maintenance
It is recommended that each operator of the tool be made aware of, and
responsible for, the following maintenance steps:
1.
Remove dust, moisture, and other contaminants with a clean brush, or
soft, lint free cloth.
2.
Do not use any abrasive materials that could damage the tool.
3.
Make certain all pins; pivot points and bearing surfaces are protected with
a thin coat of high quality machine oil. Do not oil excessively. The tool
was engineered for durability but like any other equipment it needs
cleaning and lubrication for a maximum service life of trouble free
crimping. Light oil (such as 30 weight automotive oil) used at the oil
points, every 5,000 crimps or 3 months, will significantly enhance the tool
life.
4.
Wipe excess oil from hand tool, particularly from crimping area. Oil transferred from the crimping area onto
certain terminations may affect the electrical characteristics of an application.
5.
When tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping dies,
and store the tool in a clean, dry area.
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
Do Not
force the handles open or closed.
The tool will open easily by
pressing up on the ratchet release lever in the movable handle. See Figure
11.
How to Adjust Tool Preload
(See Figure 12)
This hand tool is factory preset to 25-45 LBS. preload. It may be necessary over the life of the tool to adjust tool
handle preload force. Listed below are the steps required to adjust the crimping force of the hand tool to obtain
proper crimp conditions:
1.
Hold the hand tool in the palm of your hand as shown in Figure 10. Using the index finger squeeze the link
towards the top of the hand tool frame. This will release the preload adjustment wheel.
LUBRICATION POINTS
(BOTH SIDES) LIGHT OIL
(EVERY 3 MONTHS OR
5,000 CRIMPS)
Figure 10
RATCHET RELEASE
LEVER
Figure 11
