Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638236800 - HANDTOOL CRIMP 2.5MM BOARDIN PIN
Contact us: [email protected] Website: www.integrated-circuit.com
Hand Crimp Tool For
2.50mm (.098") Board-In Connector, Mini. Crimp Pin
Doc No: ATS-638236800
Release Date: 10-25-10
UNCONTROLLED COPY
Page 4 of 7
Revision: A
Revision Date: 10-25-10
Figure 8
PUSH ON
HANDLE
PULL OPEN
TOOLING
TOOLING
M3 BHCS
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
8.
Remove the crimped terminal from the terminal
locator by pulling on the wire.
9.
Visually inspect the crimped terminal for proper
crimp location.
10.
On some large O.D. wires, it may not be possible to
insert the wire with the tool partially closed. Those
wires should be inserted with the hand tool in the
open position. Insert the wire above the terminal in
the punch and against the wire stop then close the
tool. See Figure 6.
Locator Replacement
See the parts list on the last page of this document for
the proper locator order number. Follow the steps
below to replace the locator.
1.
Open the crimp hand tool.
2.
Squeeze gently on the lower area shown in
Figure 7A with your thumb and index finger.
The lower tabs of the locator should disengage
from the hand tool.
3.
Lift and pull away from the hand tool. The top
locator hooks should slip out of the top slots
easily. See Figure 7A.
4.
To reinstall the new locator, make sure the hand
tool is in the open position.
5.
Press the red insert down as far as it will go as
shown in Figure 7B.
6.
Holding onto the lower part of the locator with your
thumb and index finger, insert the locators top
hooks (2) into the hand tool top slots.
7.
Rotate the locator down and press the lower tabs
into the two bottom slots of the hand tool. To
secure the locator into place, the lower tabs must
snap into place on the hand tool frame.
TERMINAL
Figure 6
WIRE
WIRE STOP
SQUEEZE
HERE
SQUEEZE
HERE
LOCATOR
Figure 7A
TOP HOOKS
TOP SLOTS OF
HANDTOOL
LOWER TABS
Figure 1
HANDLE WILL
SPRING OPEN
SQUEEZE
HANDLES
Figure 7B
5 / 8
5 / 8
