Auto Grip Pull Tester
Doc No: TM-638019100
Release Date: 08-10-09
UNCONTROLLED COPY
Page 15 of 20
Revision: E
Revision Date: 03-19-21
2.6
Settings and Functions
RS-232C Bi-directional Interface Functions (See Chart below)
Connect the gauge to an external data receiving device with the optional RS-232C cable (Order
No. 63801-9151) or USB cable. See Optional Cables and Software below.
All gauge functions can be duplicated from a remote location by using the RS-232C or USB
interfaces.
All commands must be sent in uppercase ASCII character format followed by [Enter].
Signal level: RS-232C, 8 data bits, 1 stop bit, and no parity bit.
Baud rate: 19200 bps; USB 256000bps.
RS-232C Interface Functions (Upper case ASCII format)
Command
Function
Response*
K [Enter]
Select “kgf/gf” units
R [Enter] executed E [Enter] error*
N [Enter]
Select “N” units
O [Enter]
Select “lbf/ozf” units
P [Enter]
Select peak mode
T [Enter]
Select real time mode
Z [Enter]
Tare Display
Q [Enter]
Turn off power
EHHHHLLLL [Enter]
**
Set high/low set points(4 digit) HHHH=High, LLLL=Low
E [Enter]
**
Read high/low set points
EHHHHLLLL [Enter]
**
set point values (4 digit)
HHHH=High, LLLL=Low
D [Enter]
Transmit display data
[Value][Units][Mode][Judgement]
*
E [Enter] response if the command is not accepted.
**
Ignore decimal point for high low set points
Optional Cables and Software
To capture and analyze the peak data from the force gauge, a running log of all the data is
displayed along with a chart. Calculate max/min, average and standard deviation.
Order No.
Description
Type
63801-9150
Software, Data Acquisition.
63801-9151 RS-232C cable (10', 9 pin female)
63801-9152
RS-232C to USB Adapter