Auto Grip Pull Tester
Doc No: TM-638019100
Release Date: 08-10-09
UNCONTROLLED COPY
Page 3 of 20
Revision: E
Revision Date: 03-19-21
CAUTION
When mounting display module, after recalibration or repair, use M4 mounting screws with a maximum
insertion depth of 5mm
into the display module.
Only use mounting hardware supplied.
Hand tighten wire terminal grip only. Do not use tools
Do not remove the warranty seal or disassemble the display module. Disassembly will void the warranty.
Never
perform any service or maintenance other than as described in this manual.
Never
modify, alter or misuse the equipment
Molex crimp specifications are valid only when used with Molex terminals, applicators and tooling.
Failure to observe this precaution may result in injury and property damage.
Tooling Technical Assistance
Molex offers tooling technical assistance for customers who may need some guidance for tooling
adjustments. This support can be obtained by calling the number listed below.
This assistance is limited to the operation and setup of a customer’s Molex Tester. Questions with
regard to Molex connector products or how to identify the proper tooling or tooling documentation
should be directed to your local Molex personnel or Customer Service Representative.
When calling for service on the press, a copy of the Tooling Manual and Specific Applicator Tooling
Specification Sheet should be present as well as a person who is familiar with the applicator should
be present. Be sure the following information is supplied:
1.
Customer name
2.
Customer address
3.
Person to contact (name, title, e-mail, and telephone number)
4.
Pull Tester order number
5.
Serial number (Lease number also if applicable)
6.
Molex connector product order number
7.
Urgency of request
8.
Nature of problem
Application Tooling Support
Phone: (402) 458-TOOL (8665)
E-Mail: [email protected]
Website: www.molex.com/applicationtooling
Molex is a registered trademark of Molex, LLC in the United States of America and may be registered in other countries; all
other trademarks listed herein belong to their respective owners.