0112-0102 E
12
Chapter 2: Setting Up the Instrument
Before you unpack and set up the instrument, prepare a dry, flat work area that is away from
direct sunlight, dust, drafts, vibration, and moisture. The work area must have sufficient
space for the instrument, host computer, and required cables. To provide access for
disconnecting power from the instrument, maintain a 20 cm to 30 cm (7.9 in. to 11.8 in.) gap
between the rear of the instrument and the wall. To ensure sufficient ventilation, do not
block the ventilation grids on the front and rear of the instrument.
The package contains the instrument and the following accessories:
SoftMax Pro Software, product key, and installation guide
Instrument installation guide
USB computer connection cable
AC power adapter
Plate adapter
For a complete list of the package contents, see the enclosed packing list.
Before you set up the instrument, you should install the SoftMax Pro Software on the
computer that you plan to use to operate the instrument. See the
SoftMax Pro Data
Acquisition and Analysis Software Installation Guide
.
Unpacking the Instrument
The packaging is designed to protect the instrument during shipment. Tape is placed on the
cuvette door to protect the instrument from damage during shipment.
CAUTION!
Do not touch or loosen screws or parts other than those specifically
designated in the instructions. Doing so could cause misalignment and possibly void
the warranty.
The instrument is packed in a specially designed carton. Before you unpack the instrument,
check the box for any damage that might have occurred during transportation. If any
damage is noted, inform the supplier immediately and keep the damaged packaging.
Note:
Retain the shipping box and all packing materials for future transport needs.
To unpack the instrument:
1. Open the top of the box.
2. Lift the accessories tool box and the instrument from the package, and then place the
instrument on a level surface.
3. Remove the cardboard divider from the top of the instrument.
4. Remove the packing material from both ends of the instrument, remove the instrument
from the plastic bag, and then set the instrument down carefully on a level surface.
5. Remove the tape from the cuvette door.
2
