SkanWasher 400 User Guide
23
Chapter 5: Operation
Starting a Wash Program
Step 1
Edit or create wash program using the Edit Program through Setup
Main Menu.
Step 2
Verify appropriate liquid is in reservoir bottle.
Step 3
Verify connections.
Verify buffer reservoir is connected to Inlet port and pressurized.
Verify waste bottle is connected to Waste port.
Step 4
Prime system.
Place sample microplate on the microplate holder.
Check pattern on the side of microplate holder to verify that the
holder is in the correct plate configuration.
Press
[Rinse]
key to enter prime program.
Press
[Start].
Repeat 3 times.
Step 5
Choose Wash Program.
Press Program key from control panel (Program LED will illumi-
nate).
Select a Wash program using the Up/Down Arrow keys to move
cursor to previously created/edited program.
Press
[Enter]
.
TIP:
Program mode can be entered
only when system is Ready.
(Ready LED will illuminate).
If system is in Setup menu, press
[Setup]
key to return to Main
Menu.
To exit the Program mode with-
out selecting a program, press the
[Program]
key.
