Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 59 / 78

Appendix
A
:
Serial Communication Option (RS-232)
SkanWasher 300 User Guide A-3
Communication Protocol
The communication protocol is designed as a one-character command/reply
protocol. The host sends one ASCII character and the washer replies that the
command has been received and performs the action.
Commands entered by pressing keys on the front panel of the washer are
accepted in the same way as those sent via serial communication.
Table A-1: Character Commands Recognized
Command
Sent from
Host
Description
Reply from
SkanWasher
400
‘G’/ ‘g’
47h/67h Go/Start—This performs the same function as
pressing the Start key on the control panel. The
SkanWasher 300 begins washing the micro-
plate using the currently selected wash pro-
gram.
If sensor check is enabled, vacuum level, air
pressure, waste level, and microplate sensor
will be verified prior to initiating the wash.
Start command accepted
→
Reply ‘G’
Not accepted due to sensor alarm
→
Reply ‘E’
When wash sequence finished
→
Reply ‘!’
‘G’ - 47h
‘E’ - 45h
‘!’ - 21h
‘S’/ ‘s’
57h/73h Stop—interrupt the current action of the Skan-
Washer. This command performs the same
function as pressing the Stop key on the control
panel. The Stop command must be sent twice:
1. Stop
→
Interrupt operation
→
Reply ‘S’
2. Stop
→
Return to Ready mode
→
Reply ‘!’
‘S’ - 53h
‘!’ - 21h
‘!’ - 21h Attention—The SkanWasher does not perform
an action but sends a reply that it has received a
command and is responding.
Reply ‘!’ ‘!’ - 21h
‘1’ - 31h
‘2’ - 32h
------
‘8’ - 38h Select wash program. The wash program is
chosen from the control panel on the Skan-
Washer. Only defined wash programs can be
selected.
Select program accepted
→
Reply ‘n’ where ‘n’
is the program selected.
Select program not defined
→
Reply ‘#’
‘n’ - 3nh
n: selected
program
‘#’ - 23h