Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 51 / 78

Troubleshooting
SkanWasher 300 User Guide 41
Error Messages
When an error condition occurs, the SkanWasher 300 stops operation and an
alarm signal is heard. The LED Ready light flashes and a message is shown in
the display.
The sensor check is performed once when the
[Start]
key is pressed to ini-
tiate a wash. During the wash, the SkanWasher 300 does not check the sen-
sors.
Error Cause Things to Try
E-01 Bad Vacuum Low vacuum at the
vacuum outlet when
starting wash.(Vac-
uum must be higher
than 0.9 bar-1 bar).
‹
Verify vacuum
pump is switched
on.
‹
Verify tubing
connected properly.
‹
Verify caps on
reservoir bottles
and waste
collection vessel
are tight.
E-02 Air Pressure
Pressure High
¿À Low
¾
Verify Setup
The
[Start]
key is
pressed for wash or
rinse/prime. The actual
air pressure is not
equal to the set air
pressure value.
Low: Probably a leak.
Check that all reservoir
caps are tightened.
High: Due to changed air
pressure setting. The previ-
ously used wash program
had a higher air pressure
setting. Open reservoir cap
to release excess air pres-
sure.
E-03 MicroPlate
No Plate In Lift
¾¾ Insert
Plate
The
[Start]
key has
been pressed for wash
or rinse/prime, but no
microplate is in the
plate holder.
Insert a microplate.