Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 34 / 78

Maintenance
24 SkanWasher 300 User Guide
Empty Wash Head Procedure
Daily maintenance should be performed to remove any buffer from the lines.
This will prevent crystallization of salts in the probes or wash head. Rinse sys-
tem with 20% ETOH solution to deter bacterial and fungal contamination.
Follow ETOH solution with a rinse with water. If the unit will not be used for
more than a few days, empty the wash head by performing a reverse flush.
Step 1 Verify Daily Maintenance performed.
Step 2 Disable sensors.
z
Go to Setup Main Menu, select Edit Options, choose Sensor On/
Off.
z
Disable sensors.
Step 3 Disconnect liquid and pressure lines from the left side of the instru-
ment.
Step 4 Verify waste tubing is connected to vacuum port and vacuum pump
is on.
Step 5 Insert an empty microplate into the microplate holder.
Step 6 Reverse flush the wash head through Rinse port
‹
Start Rinse program by pressing the
[Rinse]
key to enter the
Rinse mode.
‹
Press the
[Rinse]
key a second time to start the rinse program.
(This will blow air through the washhead to remove any
remaining liquid.)
‹
Move waste tubing from vacuum port to “Rinse” port just prior to
dispensing.
‹
Repeat 2x.
‹
Reconnect waste tubing back to vacuum port.
Step 7 Reverse flush the wash head through Inlet port
‹
Start Prime program.
‹
Press the
[Rinse]
key to enter the Prime mode.
‹
Press the
[Start]
key to start the prime program.
(This will blow air through the washhead to remove any
remaining liquid.)
‹
Move waste tubing from vacuum port to “Inlet” port just prior to
dispensing.
‹
Repeat 2x.