Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 20 / 78

Parts and Description
12 SkanWasher 300 User Guide
Part Description
Inlet ports Located on the left side of the unit’s wash head. Two reser-
voir containers can be connected to the Inlet and Rinse
ports. Two 4 L reservoir bottles are provided with the sys-
tem to accommodate a buffer (blue color-coded tubing)
and rinse (green color-coded tubing) solution.
Vacuum port Located on the left side of the unit. The waste collection
reservoir is connected to this port via the waste tubing (red
color-coded). It is recommended to use the waste collec-
tion vessel that is provided with the system.Vacuum pres-
sure is adjusted using gauge on vacuum pump.
Pressure
ports Located on the left side of the unit. The pressure tubing
(yellow color-coded) is connected to these ports from the
buffer and rinse reservoir bottle.
Main power Located on the back panel of the unit. This contains the
main power receptacle, which includes the power switch
and fuses (1 amp for 230 Vac/ 2 amp for 115 Vac). The
selected voltage setting (110-220 VAC or 220-240 VAC)
will point towards the white arrow. Up to three power
cords are included with the system to handle either voltage
settings as well as UK power plug. Consult
Chapter 2:
Installation for directions to change fuses and/or voltage
setting.
Waste alarm
connector Located on the back panel of the unit. The waste alarm
cable is connected to this port.
Microplate
holder Most commonly available 96-well microplates may be
used with this instrument, including V- and C- shaped bot-
tom plates. The instrument is factory set for flat- and
round-bottom microplates. To ensure excellent aspiration
and low residual volume, the aspiration probe must be
positioned at the bottom of the well. This can be adjusted
through the on-board software program.