Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 11 / 78

SkanWasher 300 User Guide 4
Chapter 2: Installation
Step 1 Verify voltage is properly set for incoming line voltage.
‹
Check that the current voltage setting is pointing to the small
white mark.
Step 2 Change voltage setting, if indicated.
‹
Pry open the fuse compartment with a small screwdriver.
‹
Turn the switch around until the proper setting is pointing to the
small white mark on the bottom of the casing.
‹
Verify correct fuses are in place, change if indicated.
z
230 VAC= 1A fuse
z
115 VAC = 2A fuse
‹
Reinstall switch.
Step 3 Connect the power cord.
‹
Insert the power cord into the receptacle located on the back of
the instrument.
‹
Plug the power cord into the main power outlet.
&
TIP:
Save the packing material for
future use in shipping instrument.
!! IMPORTANT: Fuse compartment
is located below the main power
receptacle on the back of the
instrument.
S
CAUTION:
Before connecting
the main power, ensure voltage
setting is correct (Step 1).