Section 6 - Operation
WARNING
Ensure that you have fully read "Section 3 - Safety" before operating the
controller.
The Operation section of the manual describes how use the controller. This
includes stopping and starting the controller, how to adjust temperatures and
settings and how to recognize alarms.
6.1 Isolate the Controller
The main power switch is sufficiently rated to disconnect the total load current
during switch on and switch off. To prevent its operation during maintenance,
you can use a suitably-sized padlock or similar device to lock the switch in
the off position.
6.2 Switch On
When the controller is switched on, all zones go into Stop mode.
6.3 Switch Off (Shutdown)
NOTE
Mold-Masters recommends that you use the console to shut down the
heating load.
1. On the Main page, choose
[Stop]
to shut down the heating load.
2. Pull down the breaker switch to shut down the controller.
6-1
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
OPERATION
Me6 & Me12 Controller User Manual
