5.8 Set Boost Temperature
The Boost temperature may be individually set for each zone as described in
the table below.
When Boost is activated, the controller will raise the zone temperature.
NOTE
On a slow responding manifold, if you set a high Boost temperature, the
zone may not reach the set Boost temperature before the Boost time limit
expires.
The Boost period is user-configurable. To set the Boost period, see section
"5.4 Set the Global Parameters".
1. Choose [
Tool
] to open the ToolStore page.
2. Choose [
Setup
] to open the Setup Tool page. If prompted, enter the
System password.
3. Choose one or more zones, using one of the following methods.
• Choose one zone at a time until you have selected all the required
zones.
•
Choose the first zone, the last zone, and [
Range
] to include all the
zones in between.
5-12
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SETUP
Me6 & Me12 Controller User Manual
