Section 6 - Operation
WARNING
Read “Section 3 - Safety” before setting up or operating the E-Drive
controller.
6.1 Powering the Controller
CAUTION
Before you turn on the controller ensure that all motor power and encoder
cables are properly connected based on how the cables are labeled.
Any damage to the motor cables can cause performance issues and/or
motor failure.
CAUTION
IMPORTANT
Ensure that the mechanical assembly is completed, that the valve pins are
connected to the valve pin holder, and that the motor is correctly mounted
to the plate or manifold.
For all E-Drive controllers, the main power disconnect is a rotary switch
located at the back of the controller. This switch is rated to safely handle the
total load current when switched off.
After the bootup process is complete, you will see the default motion control
screen. See “4.7 Main Screen” on page 4-3 for more information.
6.2 Logging-in
You can operate the E-Drive system as the default user Guest. For certain
changes, you must log-in. The controller has the default password of “1” for
Supervisor.
NOTE
Any loss of power to the controller requires the user to log-in again.
1. Choose
Guest
.
6-1
OPERATION
E-Drive Controller User Manual
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
