Mokai ES-KAPE 2.0, Руководство пользователя, Страница: 13 / 19

13
Operating Information and Pre-ride Check
Pre-Ride Check

General Inspection of Craft insuring modular sections are attached
properly.

Review Kohler pre-start checklist (pg 4-Kohler manual). Install
Engine, lock in place.

Check that Fuel Switch is in the ON (pointed down) position

Check Fuel and Vent Connect Lines

Secure Engine Cover
DO NOT OPERATE BOAT WITHOUT ENGINE COVER IN
PLACE. COVER IS REQUIRED FOR EFFECTIVE ENGINE
COOLING.

General inspection of Jet Pump

Check Steering

Check Emergency shut off lanyard key by starting engine and
pulling key or depressing button to ensure that engine stops.
(Can be done on dry land. If in water, board MOKAI before starting.)

Check Safety Equipment
Boarding
From land or dock, board the MOKAI at the center of the occupant
compartment.
*IMPORTANT*
MOKAI is not designed for re-entry in deep water. In an emergency
situation, re-boarding is only possible from the bow or the stern. Do not
attempt to re-board from the sides of the MOKAI.
Shallow Water Operation
We recommend starting the MOKAI in 12 inches of clear water. The draft is
4-6 inches. Every MOKAI is equipped with an intake grate to protect debris
from entering the jet pump and causing damage when operating. Owner
assumes all liability for damage when operating with removed or altered
grate.
Debris hazards and loose vegetation tend to be found in shallow water and can
be sucked onto the intake grate. If this occurs you will notice a decrease in
speed due to the blockage of water flow to the jet drive.
Simply stop engine, debris should fall free from intake grate. If necessary,
remove any tangled debris from grate by hand before restarting.