Mohlenhoff WSK 180, Руководство пользователя, Страница: 31 / 100

31
ENG
DEU
RUS
ITA
DAN
Installation
*not included in the scope of delivery
�
Level the system convector to an even height dimension using an Allen key (4
mm) (see „Levelling“).
�
Fix the system convector to the raw floor using the provided fixing points. Use
a dowel* and a sufficiently long 6 mm countersunk head screw* as well as the
provided rosette washers for this.
�
Position the traverse to the required location and press on firmly. Take care that
it is positioned flushing on the bottom plate between the side parts edges.
Install the traverse
Fixing the system convector, lateral view Fixing the system convector, front view
System extensions
Interior system connectors
System connectors (SV) are required to connect two system convector troughs or
convector parts to each other. The connection is performed in the inside as a stand-
ard. If inside connection is impossible, it is also possible from the outside. System
convector parts with mitre fit are delivered ready-to-plug-in; they are also connected
to each other with system connectors. The number of system connectors depends
on the system convector height:
System convector height Number of system connectors
91 mm 1 set
111 mm 1 set
141 mm 2 sets
191 mm 2 sets
�
Push the connectors in even distances into the grooves of the convector trough.
�
Pull together the convector troughs so that they flush.
�
Fix the connection by means of stud screws M6 and an Allen key of size 3.
Exterior system connectors