Mohlenhoff WSK 180, Руководство пользователя, Страница: 30 / 100

30
ENG
DEU
RUS
ITA
DAN
Installation
View from below and lateral view
Exterior adjustment block with fixing: Fix with screws
Exterior adjustment block with foot: Latch into the trough profile
1
2
1
2
Installation with exterior adjustment blocks Installation with interior adjustment blocks
Caution
Permanent damage to the device!
In order to protect the WSK/WSKP against floating when bringing in cast
plasters/flowing screeds, fix the device at the raw floor at a minimum of
two points using adjustment blocks.
Caution
Permanent damage to the device!
In order to protect the system convector against floating when bringing
in cast plasters/flowing screeds, fix the device at the raw floor at two
provided points using adjustment blocks.
The adjustment blocks included in the scope of delivery are only
intended for levelling purposes! In order to obtain step-on ability,
increase the number of adjustment blocks or support the WSK/
WSKP over the entire surface (see also „Step-on ability“).
A traverse mounted to the bottom of the system convector is required additionally in
case of installation with interior adjustment blocks. This will distribute all load forces
to the entire system convector.
�
Insert the adjustment blocks into the traverse and screw them in until they pro-
trude a little on the opposite side.
�
Tear off the protection foil from the adhesive tape. Keep the adhesive surface
free from dust and grease in order to preserve the adhesion.
*
Install interior adjustment
blocks Remove protective foil