®
SANI-STREAM
by MOEN
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT AT INSTALLATION SITE
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nut is in place. The cartridge and
retainer nut were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through
the handling of the valve by any number of persons the retainer nut may not be properly installed. This should be carefully checked
at time of rough-in and trim-out. If the retainer nut is not properly installed, water pressure could force the cartridge out of the casting.
Personal injury or water damage to the premises could result.
CAUTION:
Always turn water off before disassembling the valve. Open both faucet handles to
alleviate water pressure to insure that complete water shut-off has been accomplished.
2 HANDLE WIDESPREAD
MT016B
(78392)
Model #8130 (6" Wrist Blade Handles)
Model #8134 (6" Wrist Blade Handles w/Waste)
Model #8131 (4" Wrist Blade Handles)
Model #8135 (4" Wrist Blade Handles w/Waste)
C
1-1/4" MAX
DECK THICKNESS
4" TO 38" CENTERS
FLEXIBLE
HOSE
4"
1/2" IPS
COLD INLET
1/2" IPS
HOT INLET
4"
H
6"
1 3/4"
2 1/8"
DECK HOLE
SIZE (1-3/8")
DECK HOLE
SIZE (3/4" to 1")
