• REVERSED HOT AND COLD POSITIONS
HELPFUL HINT:
IT IS NOT NECESSARY TO SHUT OFF WATER
SUPPLIES.
1. Position handle so that it points toward you. Remove handle cap
(2)
, han-
dle screw
(3)
, handle body
(4)
and lever handle
(5)
.
2. Turn cartridge stem around so that the
notch is turned one half turn or 180°.
3. Reinstall handle. To re-install handle, press cartridge
stem down. Holding lever handle
(5)
up, hook handle
ring into groove on pivot nut
(6)
. Swing handle back and
forth until it drops into place. When finished, if you need
to press down on handle cap
(2)
to shut water off, handle is not
properly seated in pivot nut. Disassemble and repeat this step.
3
INS315A
1 (800) BUY-MOEN
[289 - 6636]
Questions,
Comments?
Call Moen!
In the U.S., call our toll free Helpline number for answers
to any product installation or warranty questions.
In Canada:
Toronto: 905-829-3400;
Rest of Canada: 1-800-465-6130
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
YOU SHOULD HAVE THE FOLLOWING INFORMATION
AVAILABLE WHEN CALLING OUR MOEN HELPLINE:
•
Faucet Model Number
•
Faucet Finish
•
Date and Location of Faucet Purchase
MOEN LIFETIME LIMITED WARRANTY
Faucets made of leaded brass alloys may contribute small amounts of lead to
water that is allowed to stand in contact with the brass. The amount of lead con-
tributed by any faucet is highest when the faucet is new. The following steps may
reduce potential exposure to lead from faucets and other parts of the plumbing
system:
•
Always run the water for a few seconds prior to use for drinking or cooking
•
Use only cold water for drinking or cooking
•
If you wish to flush the entire plumbing system of water that has been stand-
ing in the pipes or other fittings, run the cold water until the temperature of the
water drops, indicating water coming from the outside main
•
If you are concerned about lead in your water, have your water tested by a
certified laboratory in your area
This faucet has been tested under actual operating conditions and com-
plies with flow restrictions for water usage as set by the Federal Trade
Commission.
CONSUMER INFORMATION
Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the
original consumer purchaser for as long as the original consumer purchaser owns their home (the "Warranty Period" for
homeowners), that this faucet will be leak and drip-free during normal use and all parts and finishes of this faucet will be
free from defects in material and manufacturing workmanship. All other purchasers (including purchasers for industrial,
commercial and business use) are warranted for a period of 5 years from the original date of purchase (the "Warranty
Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide the
parts necessary to put the faucet back in good working condition and will replace FREE OF CHARGE, any part or finish that
proves defective in material and manufacturing workmanship, under normal installation, use and service. Replacement parts
may be obtained by calling 1-800-289-6636, or by writing to the address shown below. Proof of purchase (original sales
receipt) from the original consumer purchaser must accompany all warranty claims. Defects or damage caused by the use
of other than genuine Moen parts are not covered by this warranty. This warranty is applicable only to faucets purchased
after December 1995 and shall be effective from the date of purchase as shown on purchaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due to
installation error, product abuse, product misuse, or use of cleaners containing abrasives, alcohol or other organic sol-
vents, whether performed by a contractor, service company, or yourself, are excluded from this warranty. Moen will not be
responsible for labor charges and/or damage incurred in installation, repair or replacement, nor for any indirect, incidental
or consequential damages, losses, injury or costs of any nature relating to this faucet. Except as provided by law, this war-
ranty is in lieu of and excludes all other warranties, conditions and guarantees, whether expressed or implied, statutory or
otherwise, including without restriction those of merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also
have other rights which vary from state to state, province to province, nation to nation. Moen will advise you of the proce-
dure to follow in making warranty claims. Simply write to Moen Incorporated using the address below. Explain the defect
and include proof of purchase and your name, address, area code and telephone number.
Moen Incorporated 25300 Al Moen Drive, North Olmsted, OH 44070-8022 U.S.A. in Canada: Moen Inc. 2816 Bristol Circle, Oakville, Ontario L6H5S7
• IRREGULAR WATER FLOW
Remove the aerator from the spout and flush thoroughly, then reinstall.
• LOW WATER FLOW
Moen aerators comply with government regulations to save both water
and energy. Your old faucet may not have met these standards.
• LEAKS FROM TOP OR BOTTOM OF SPOUT HUB
Use replacement spout seal kit, replace and reassemble following
instructions included with kit #117.
• DRIPS FROM SPOUT/LEAKS THROUGH HANDLE
Replace Moen 1225 Cartridge with new one. Instructions are included
with the 1225 cartridge.
8
IMPORTANT:
Pipe chips, sand, stones and other solids found in new and renovated
plumbing can damage the sealing surfaces of the cartridge and cause leaks. To avoid
damages,
DO NOT TURN ON SUPPLY VALVES
until instructed below.
1. Unscrew aerator.
2. Turn faucet on in the full cold position (handle pointing to the right) and turn on the cold
supply for 15 seconds.
3. Without turning the faucet off, turn the handle to the full hot position (handle pointing to
the left) and turn on the hot supply for 15 seconds.
4. Without turning the faucet off, turn the handle to the mid/mix position (handle pointing
toward you) and turn on the spray for 15 seconds.
5. Shut off faucet.
6. Replace aerator and check system below sink for leaks.
Your new Moen faucet is now ready for normal use.
FLUSHING INSTRUCTIONS (after faucet installation)
TROUBLE SHOOTING
All that is needed to clean your faucet is a soft damp cloth. Moen does not recommend
the use of scour pads, cleansers or chemicals. The abrasive nature of these substances
could damage the faucet's finish. A non abrasive car wax will help to protect the finish.
CARE INSTRUCTIONS
TURN STEM
1/2 TURN
NOTCHED
FLAT
ON STEM
